-5%اتمام موجودی
Temperature control range: -60℃-500℃
Temperature measurement accuracy: 1℃
Resolution: 0.1℃
Refresh rate: 0.5S
Supply voltage: DC 12V
24V Measurement input K-type thermocouple
Output: 10A relay
Opening size: 74MM X 39MM
Before using, first understand the function of the K-type thermocouple thermostat. The product has a total of four buttons, plus button, minus button, SET (setting button), reset button. There are two sets of digital tubes showing the actual temperature and the set temperature respectively. All parameters are automatically remembered after 5 seconds of setting.
Operation use:
Red digital tube: actual temperature,
Blue digital tube: set the temperature
Button plus: Increase the set temperature.
Minus button: Decrease the setting temperature.
Restore factory settings: press and hold the plus button for more than 5s at the same time, the system will restore the original settings data.
Set button (SET):
1. Short press SET, set the temperature to add 50 °C at any time, the user can quickly press SET to quickly set close to the preset temperature value, and then fine-tune to the preset temperature by pressing the button.
2. Press and hold SET to enter the parameter setting options. There are multiple parameters from P00~P05 for users to set. After entering the parameter interface, short press SET to switch P00 ~ P05. Under the corresponding parameters, the corresponding data is added or subtracted by pressing the button, and the automatic save data is back to the display interface after the system is completed for 10 seconds.
Parameter name Function introduction Initial value
P00 H heating mode / C cooling mode H heating mode
P01 Hysteresis temperature 0-50C 2 ℃
P02 temperature correction -10C-10C 0 ℃
P03 temperature upper limit alarm value 500 ℃
P04 lower temperature alarm value -60 ℃
P05 data lock OFF
